Solar LED street light installation method

Perhaps the engineering purchaser is not very clear about the engineering installation and precautions of the solar street light. Therefore, we will share some instructions and installation diagrams for the installation of solar street lights and the installation of wind and solar hybrid lights. Please see below:

Solar street light installation:

1) After the pole is installed, start the wires of all components (solar panel, battery, light source) to the controller. (Specific controller wiring see the illustration)

2). Connect the wires of the light source directly to the wires of the battery to see if the light source is on. You can determine the positive and negative poles of the wires of the light source. (The light source is not bright after the positive and negative poles of the light source are connected, and the light source will not be damaged. Feel free to test the lamp), then connect the positive wire of the light source to the red line corresponding to the bulb icon on the controller, and connect the negative pole of the light source to the black line corresponding to the bulb icon on the controller.

3) Use the multimeter DC voltage file to check the positive and negative poles of the battery outlet, connect the positive pole of the battery to the red line corresponding to the battery diagram on the controller, and connect the negative pole of the battery to the controller. Black line.

4). Check the positive and negative poles of the solar panel outlet with the multimeter DC voltage file, connect the positive electrode of the solar panel to the red line corresponding to the solar panel on the controller, and connect the negative wire of the solar panel to the controller. There is a black line corresponding to the solar panel.

5). The controller has been debugged with the program and intelligent lighting time. The controller does not need to debug the controller after wiring, and the controller will actively enter the working state.

6). Note: When installing the battery box, tighten the screw and the waterproof threading pipe. The waterproof threading pipe should be 20 cm higher than the ground on the base of the pole to ensure that the water will not enter the water when the water is soaked. In the battery box. In addition, the installation location is chosen to avoid obstacles blocking the solar panels, so that the solar panels cannot be contacted and cannot be charged.

The above content is provided by WOSEN. WOSEN is a professional manufacturer and supplier of Led Flood Light, Led Street Light, Led Solar Light, etc. For more information, please visit https://www.wosenled.com/ or contact admin@wosenled.com or WhatsApp +86-13425434349